STM32 ST-LINK Utility (STSW-LINK004) is a full-featured software interface for programming STM32 microcontrollers. It provides an easy-to-use and efficient environment for reading, writing and verifying a memory device. Tools used: keil ide: stm32cubemx: STM32 ST-LINK utility http://www.st.com/en/development-tool.
SEGGER offers a firmware upgrading the ST-LINK on-board on the Nucleo and Discovery Boards.
Microsoft access odbc error. An update was created to detect lost connections and reestablish them on next use and was released with the MSI update in May 2017 and included with Office 365 builds starting with build 1611.
This firmware makes the ST-LINK on-board compatible with J-Link OB, allowing users to take advantage of most J-Link features like the ultra fast flash download and debugging speed or the free-to-use GDBServer.
Getting Started with ST-LINK On-Board
In order to get started with ST-LINK on-board and upgrade it to a J-Link OB, just a few steps are necessary:
ResourcesSt-link Utility Software DownloadTerms of use
SEGGER created a firmware which runs on the ST-LINK on-board, making it J-Link compatible. In order to make use of this firmware, the following Terms Of Use must be accepted:
If there is any doubt if a certain use may be considered within the foregoing scope it is strongly recommended to consult SEGGER prior to use.
When starting a debug session, the following license dialog shows up which must be accepted in order to be able to work with ST-LINK on-board:
Compatible Evaluation Boards
The following evaluation boards have been tested with the J-Link OB firmware and are known to be working. Other evaluation boards may work as well but are not guaranteed to do so. In case of doubt, please consult SEGGER. The pictured evaluation boards are examples only. Other models might vary in layout.
Restore ST-Link Firmware
If, for whatever reason, the original ST-LINK firmware shall be restored and the ST-LINK on-board is already running the J-Link firmware, this can be achieved via the STLinkReflash utility:
St Link V2 Schematic
Firmware Version History and Limitations
17-06-28:
16-08-04:
16-04-15:
16-05-04:
The firmware making the ST-LINK on-board J-Link compatible has some limitations in contrast to an original, industry leading SEGGER J-Link:
By using an original SEGGER J-Link PRO, J-Link ULTRA+ or J-Link PLUS, all these limitations will be gone. Learn more about J-Link.
ResourcesPurchaseTechnologyAccessoriesToolsModelsComments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |